QUICK AND EASY BUILD

VAN SHELF ASSEMBLY

Van racking units are supplied flat packed so we can get them shipped to you quickly and cost efficiently. They are quick and easy to build, taking around 10 minutes. All fixings are included, you just need to supply a little wood glue. See the video below for a complete shelf unit build.

Due to variations in van lining a small amount of trimming maybe required to the end panels.

VANIFY SHELVING SYSTEMS

Van Shelf Assembly Instructions

STEP 1

For standard compartment shelves (A): insert shelf dividers into the shelf base. The tenons on the dividers will insert into the mortices on the base. Next attach the shelf front and rear pieces. At each stage apply glue to the surfaces that are being joined. Repeat for each shelf.

For angled toolbox shelves (B): line up the mortice and tenon joint of the two pieces and slot together. Apply glue to the joining surfaces. Repeat for each shelf.

STEP 2

IMPORTANT: Each side panel will have one, two or three dots. The panel with the lowest number of dots goes closest to the front of the van.

For example: Panel A has 2 dots, Panel B has 3 dots. Panel A is the side panel that is closest to the front of the van. Panel B is closest to the rear of the vehicle.

IF YOU ARE UNSURE FIT THE SHELVES INTO THE SIDE PANELS WITHOUT GLUE UNTIL YOU HAVE TESTED THE FIT IN YOUR VAN.

STEP 3

Line up the tenons of the assembled shelves with the mortices in one of the shelf sides and slot into place. Repeat with the second side. Glue all of the joining surfaces. A rubber mallet will help endure that the tenons are fully bedded into their corresponding mortice.

Attach the bottom strip to the shelf unit
(note: this piece is only for certain units)

STEP 4

Using the screws included with your purchase secure each shelf into place as indicated in the diagram. See the video above for a complete shelving unit build.

Have any questions? Contact us.

IMPORTANT

VAN RACK SIDE PANELS

Make sure that the side panels are on the correct sides (left or right) of the shelving unit before gluing. The panel with the fewer number of dots is the one closest to the front of the vehicle as in the image below.
So Easy To Build
EVEN AN 8 YEAR OLD CAN DO IT!
Shop now